Car Accessories Installations in Houston
There
are several accessories for cars in the market. Customizing cars have become a
trend today. For some it is to add a personal touch to their car and for others
just a show-off. The installation of car accessories in Houston comes out to be quite expensive but with good
service. So if incase you wanted to do these things yourself then here are a
few self to do car accessory installations listed below:
CAR
ALARM INSTALLATION
Opening
a car lock or door has become just too easy for anyone. It is possible by just
using a normal ruler. This has led to an increase in a lot of car thefts. So it
has become important to install alarms in cars for their safety and security. Car alarm Houston gives you that
security without any doubt.
Car
alarm installation is a very mazy and complicated process which requires
specific knowledge about working with wires. The accessories you require are
sirens, LEDs, door opening protection, adjustable shock sensors, and output for
parking flash lights, tilt sensors, air horns, door sensors, trunk, hood and
door pins, and starter disable relays. For installation: Firstly, choose a
suitable place where you can place your alarm, dash light, siren, reset switch.
Then collect materials like solder gun, test light, knife, double sided
mounting tape and voltmeter. Now read the installation manual carefully which
comes with the alarm. The important things to be careful about are LED
positioning, placement of the alarm module and the wiring. If these three are
done correctly your alarm will function properly.
If the
car stereo installation professionals charge you a good deal of money then let
me tell you that you can do this job all by yourself. It is not as difficult a
task as it seems to be. All you need is wire cutters, wire stripper, electrical
tape, screw wire set and a new car stereo.
Once
you have these you are ready to install your stereo.
Firstly
remove the old stereo and disconnect the ground cable from the battery. Now
connect the positive and negative terminal of the battery to the positive and
negative terminal of the new stereo respectively. The negative wire should be
attached to the metal and should be screwed in the dashboard near the radio.
Cabling strap has a connector attached to it and all the wires should be
connected to it. Now you can attach the negative cable back to the battery and
fix your new stereo.
CAR
AUDIO INSTALLATION:
Car
audio is an important accessory in the car and car security system for an
enjoyable ride since most of the people are fond of music. Installation of the
car speakers is not a tough job; all you need is a little knowledge and common
sense. First of all you need to decide as to where the speakers will be placed.
The distance of both the speakers should be at an equal distance from the
centre for good quality of voice. Choosing a location for woofers and
amplifiers is comparatively easy. Wiring is another important part of the
installation; you need to buy a correct cable according to the capacity of the
amplifier and speakers. A final fine tuning which can be done with the help of
the professionals and your installation is done.
Comments
Post a Comment